Products
- 1-18 GHz Horn antenna + Preamp
- 30dB Gain
- Excellent Matching and ease of use
- Battery Operated CHarges through USB charger included
The H20, H10, H5, and E5 are magnetic field (H) and electric field (E) probes for radiated emissions EMC pre-compliance measurements. The probes are used in the near field of sources of electromagnetic radiation. They serve to locate and identify potential sources of interference within the building blocks of electronic assemblies. The probes act similar to wide bandwidth antennas, picking up radiated emissions from components, PCB traces, housing openings or gaps, and from any other parts that could be emitting RF. The probes are usually connected to a spectrum analyzer. Scanning the probe over the surface of a PCB assembly or housing quickly identifies locations that emit electromagnetic radiation. By changing to a probe with a smaller size, the origination of the emissions can be further narrowed down.
The ESD-Sense has been developed with EMC test laboratories in mind to enable a “go / no-go” verification of the ESD generator output prior to test.
Diode Pulse Limiter with built-in 10 dB high power attenuator and fuse lamp to protect sensitive measuring equipment when measuring spectra with high energy. Thanks to the built-in fuse lamp, serious overload situations of sensitive equipment can be recognized fast and reliably. A replacement bulb is placed inside the unit. The pulse limiter prevents expensive equipment defects. The very flat frequency response allows high measurement accuracy, even if only a few sample values are used for correction.
Diode Pulse Limiter with built-in 20 dB high power attenuator and fuse lamp to protect sensitive measuring equipment when measuring spectra with high energy. Thanks to the built-in fuse lamp, serious overload situations of sensitive equipment can be recognized fast and reliably. A replacement bulb is placed inside the unit. The pulse limiter prevents expensive equipment defects. The very flat frequency response allows high measurement accuracy, even if only a few sample values are used for correction.
The broadband horn antenna BBHA 9120 E is a linear polarized double ridged horn antenna
- (0.8) 1 GHz to 6 GHz
- N - female
The Multiple Control Device NCD is suited for the operation of optionally up to 8 devices with multiple axis of motion. Those devices can be any combinations of antenna masts, turntables, cable guide rails or any other positioning equipment.
This controller NCD permits the operation in manual, semi-automatic and remote-control mode via IEEE 488.2 (GPIB bus), or optionally other interfaces, of multiple devices simultaneously.
The controller FCU3.0 is suited for the operation of up to four devices with multiple axis of motion. Those devices can be any combinations of antenna masts, turntables, cable guide rails or any other positioning equipment. Furthermore, the FCU3.0 permits the operation in manual, semi-automatic and remote control of multiple devices simultaneously via Ethernet.
Other diameters and load capabilities are available on request.
The controller FCU3.0 S is suited for the operation of one(1) devices with multiple axis of motion. Those devices can be any combinations of antenna masts, turntables, cable guide rails or any other positioning equipment. Furthermore, the FCU3.0 S permits the operation in manual, semi-automatic and remote control of one devicey via Ethernet.
Other diameters and load capabilities are available on request.
The controller FCU3.0 S Lite is suited for the operation of one(1) device with one axis of motion. Furthermore, the FCU3.0 S permits the operation in manual, semi-automatic and remote control of one devicey via Ethernet.
Other diameters and load capabilities are available on request.
