Categories

ISO 11452-4

OTHER PRODUCTS IN THE SAME STANDARD:
CDG 7000-75-10 Magnetic & Conducted Immunity, 10 kHz - 250MHz

The CDG 7000 is a new test generator for all standards on immunity to conducted disturbances induced by high-frequency fields - including BCI tests (ISO 11452-4). One of the very few combined IEC 61000-4-6 test systems that contain the RF signal generator, an RF power amplifier, a 3-channel RF voltmeter, and a directional coupler at a very affordable price. IEC 60601-1-2 calling out IEC 61000-4-39 magnetic immunity for close proximity testing requirements can also now be met with the 10 kHz unit. 

BBHA 9120 J - 0.8-6.2 GHz Double Ridged Horn Antenna

The broadband horn antenna BBHA 9120 J is a linear polarized high gain antenna. The gain increases from 11 dBi at 1GHz up to more than 20 dBi at higher frequencies.

  • 800 MHz to 6.2 GHz
  • N (optional 7/16)
  • Gain 11 dBi - 20 dBi

NNBM 8124, 10 kHz - 150(400) MHz, High Voltage, 70A, single path, 5µH LISN

  • Acc. to CISPR 25 Ed. 4, CISPR 16-1-2, DO 160, MIL-STD, or ISO 7637-2
  • impedance (5µH + 1 Ohm) || 50 Ohm
  • 70 A, 1000 V (DC)
  • Switchable 50Ohm Load on measurement port
  • 1 microfarad capacitor to ground on AE side
  • BNC-jack (Type N option)

Injection Clamp Kits (ICK) EM and BCI Clamps

Absolute EMC offers an assortment of injection test kits for the use of conducted immunity. The kits can be used with many available conducted immunity systems, including the Schlöder CDG 7000, to make selection and setup easy. All calibration fixtures, injection clamps, attenuators, and termination resistors necessary for meeting the requirements of conducted immunity systems. All all-in-one systems are covered. 

EMC EPS 5cm Sheets - low permittivity EUT Support for high frequency testing

The original EMC EPS 5CM Sheets are white Expanded Polystyrene with 10cm x 10cm indentations for easy measurements. It can be cut down to size with the included razor knife. Keep your test setup looking professional with these lightweight and soft EUT supports. Ideal for the use in EMC testing for EUT and cable supports. The EMC EPS 5CM SHEETS are crush resistance able to withstand heavy weight loads without deforming. 1cm marking on the top side allows for easy positioning and test setups. Conveniently sold as sheets other sizes possible just ask. 

EMC EPS 70x150cm Support- EUT support

The original EMC EPS 70x150cm Support is white Expanded Polystyrene (EPS)

  • 150 x 100 x 70 cm.
  • Sit on top of a standard 80cm test table for a 150cm height
  • < 1.04 Permittivity
  • A new design can be pre-built or shipped flat, self-assembled, glued onsite

Loading...