Products
- Conical Logarithmic Spiral Antenna
- The CLSA 0110 offers circular polarisation over approx. one decade up to microwave frequencies.
- Frequency Range: 1 - 10 GHz
- Polarization: either LHCP or RHCP (Left or right hand circular polarisation)
- Impedance stabilization network (ISN)
- For measurements of unsymmetrical disturbance voltage on equipment for power line communication (PLC)
- Acc. to EN 50561-3, Annex B.
The High-Voltage Pulse Generator Type PG 6-401 is designed for dielectric testing of X- and Y-capacitors with standard impulse voltages 1.6/47 µs up to 6 kV acc. to IEC 384-14, etc. The generator has the same principle of operation as the IPG 809 but allows testing capacitance values of 33 nF - 470 nF. Picture: incl. Option PA 503
The pulse generator IPG 250 is designed for measuring the step response of high-impedance networks, for instance voltage dividers, oscilloscope probes etc. The generator excels by calibrated adjustment of output amplitude, short rise time and flat pulse top. The output pulse amplitude can be adjusted by use of a 10-turn potentiometer from 0 to 250 V. Positive and negative polarity can be selected.
The TBCDN-M1 is a Coupling Decoupling Network for conducted immunity testing according to IEC 61000-4-6. The TBCDN-M1 is compliant with IEC 61000-4-6 Annex D2.
The TBCG3-RN6 comb generator is primarily intended for testing radiated emission setups. It is a useful tool for validating the proper operation of the antenna and pre-amplifier, as well as the accurate set-up and configuration of the spectrum analyzer.
- 5 kHz-6 GHz,
- switchable 5, 10, 25, 50, 100 MHz,
- external: 5 kHz-200 MHz,
- 6xNiMH, AA, Charger,
- 2 monopole antennas
The TBCCP1-400K600 is a coaxial RF current monitoring probe with a 3 dB bandwidth from 400 kHz to 600 MHz and a very flat response from 1 MHz to 200 MHz.
Our custom-designed probe stand is ideal for mounting radiated immunity probes, sound probes, and small cameras.
This is one-off design and development of the transient generator specified in JLR Specification JLR -EMC-CS v1.0 Amendment 4.
It gives a good reproduction of the required CI 220 and RI 130 transients.
The RSH 113 is a crossed dipole antenna, consisting of two shortened half-wave-dipoles. The size reduction is achieved by the use of top-loading discs. The design frequency range is from 108 to 118 MHz, typical applications are measurements at instrument landing systems (ILS-Localizer). The RSH 113 has a nearly omnidirectional pattern and comes with horizontal polarisation. The antenna can be used for both, Receive and Transmit Applications and comes with a nominal impedance of 50 ?.
