Categories

CISPR 16-1-1

OTHER PRODUCTS IN THE SAME STANDARD:
EMSCOPE, 9kHz - 110MHz, 2 channel Receiver/LISN

EMI Measurements:

  • FFT-based dual-channel receiver
  • According to CISPR16-1-1
  • Peak, Quasi-Peak, and Average Detectors
  • Resolution Bandwidth Filters of 200 Hz, 9 kHz, and 120 kHz (CISPR), and 1 kHz and 10 kHz (MIL)
  • The fastest receiver in the market: Line and Neutral measurements with the 3 detectors simultaneously (6 simultaneous measurements)

EMSCOPE-RX2, 9kHz - 110MHz, 2 channel Receiver

EMI Measurements:

  • FFT-based dual-channel receiver
  • According to CISPR16-1-1
  • Peak, Quasi-Peak, and Average Detectors
  • Resolution Bandwidth Filters of 200 Hz, 9 kHz, and 120 kHz (CISPR), and 1 kHz and 10 kHz (MIL)
  • The fastest receiver in the market: Line and Neutral measurements with the 3 detectors simultaneously (6 simultaneous measurements)

EMSCOPE-RX4, 9kHz - 110MHz, 4 channel Receiver for 3 phase

EMI Measurements:

  • FFT-based dual-channel receiver
  • According to CISPR16-1-1
  • Peak, Quasi-Peak, and Average Detectors
  • Resolution Bandwidth Filters of 200 Hz, 9 kHz, and 120 kHz (CISPR), and 1 kHz and 10 kHz (MIL)
  • The fastest receiver in the market: Line and Neutral measurements with the 3 detectors simultaneously (6 simultaneous measurements)
  • Measure 4 lines of 3 phase LISN
  • The picture is shown with internal LISN [EMSCOPE RX4 LZ2]

EPS Test Table Lt - low permittivity for high frequency testing

  • The EPS Test Table Lt is a simple, inexpensive solution for your EMI testing. It is made from durable, expanded polystyrene (EPS) material and can be customized to your requirements. Complies with CISPR, ISO, & IEC requirements for having a low permittivity and can be used for additional standards.
  • High strength EPS 3lb per ft3
  • Low Permittivity >1.04
  • Made for moderate 200 lb.
  • Options
    • vinyl topper with your company logo 
    • epoxy coating for the top (can be combined with vinyl)

EPS Test Table - low permittivity for high frequency testing

The EPS Test Table is a simple, inexpensive solution for your EMI testing. It is made from durable, expanded polystyrene (EPS) material and can be customized to your requirements. Complies with CISPR, ISO, & IEC requirements for having a low permittivity and can be used for additional standards.

  • High strength EPS 3lb per ft3
  • Low Permittivity >1.04
  • Made for high loading 500 lb.
  • Options
    • vinyl topper with your company logo (shown in picture)
    • epoxy coating for the top (can be combined with vinyl)

 

BBHA 9120 L - 3-40 GHz Double Ridged Horn Antenna

The broadband horn antenna BBHA 9120 L is a linear polarized double-ridged horn antenna.

  • 3 GHz to 40 GHz.
  • 2.92 mm - female

Loading...