Categories

DEF-STAN 59-411

OTHER PRODUCTS IN THE SAME STANDARD:
DCS06 Test Generator for DEF-STN 59-411

The Conformity Assessment Business Model DCS06 Test Generator has been designed to operate with its complementary injection clamp to fully meet the pulse requirements of DCS06 when tested into a 5? load. It operates from an intuitive touch screen interface and has full phase synchronization up to 800 Hz input frequency with 1-degree steps. It has been designed with future revisions of the test standard in mind.

DCS12 Test Generator for DEF-STN 59-411

The Conformity Assessment Business Model DCS12 Test Generator meets all the DCS12 wave verification parameters for testing DC, single and three-phase equipment, that is source impedance and verification of damping and frequency when measured into a 10 Ω load. Output amplitude is software adjustable with permanent memory, should re-alignment be needed during calibration. 

  • There are three fixed outputs: 600 V, 750 V, and 2500 V
  • 15.9 kHz ±10 %
  • 10.9 kHz ±10 %

DCS05 Test Generator for DEF-STN 59-411, Switching & NEMP Levels

The Conformity Assessment Business Model DCS05 Test Generator. When coupled to its matched test clamp, the Generator produces damped oscillatory wave transients in the frequency range 500kHz to 50 MHz that meet the definition of a type 1N Generator verification requirements Defence Standard 59-411.  9 Fixed frequencies are available: 500 kHz, 1 MHz, 2 MHz, 3 MHz, 5 MHz, 10 MHz, 15 MHz, 35 MHz, and 50 MHz. 

DCS05 Test Clamp & 10Ohm Cal Fixture for DEF-STN 59-411

Matched test clamp for DCS05 Test Generator, the Generator produces damped oscillatory wave transients in the frequency range 500kHz to 50 MHz that meet the definition of a type 1N Generator verification requirements Defence Standard 59-411.  9 Fixed frequencies are available: 500 kHz, 1 MHz, 2 MHz, 3 MHz, 5 MHz, 10 MHz, 15 MHz, 35 MHz, and 50 MHz. 

DCS06 Clamp for DEF-STN 59-411

The Conformity Assessment Business Model DCS06 Clamp is designed and tuned for optimal operation in the 100 kHz frequency range and provides efficient coupling of the Defence Standard 59-411 DCS06 pulse to the EUT at voltages up to 1 kV (single turn output) and 4 kV (4 turn output). A single turn monitor loop is provided for pulse amplitude measurement during the test.

NNBM DO160-1500, 10 kHz - 400 MHz, 200A, 5µH LISN, DO-160

  • Measurement of interference voltage in vehicles, aircraft, and ships
  • 10 kHz - 400 MHz
  • 1500VDC / 650VAC up to 400Hz
  • Max current 200A, (280A limited time)
  • Impedance of each path: 5 µH || 50 Ω ±20 %

Loading...