Products
- The antennas are monopole antenna
- In a PVC-housing
- For automotive immunity testing on component level.
- Proposed in the standard ISO 11452-9
- Square induction coil
- DC - 10 MHz, 400A Cont. 600A 10min
- up to 1200A/m 5sec with MFPO 9760
- 1-meter square
- turns 1
- Immunity testing to IEC 61000-4-8, IEC 61000-4-9 and IEC 61000-4-10
- Current Transformer for IEC 61000-4-8 AC magnetic fields
- 50 or 60 Hz Feed
- Produce 1000A/m short duration testing (pulse generator)
- up to 400A continuous
- Includes stand for separately sold FESP 5410-1
- 1-18 GHz Horn antenna + Preamp
- 30dB Gain
- Excellent Matching and ease of use
- Battery Operated CHarges through USB charger included
Gtemcell develops a wide range of shielded box for commercial, industrial, and military applications. Customized solutions according to your needs!
- 5G applications
- Full Anechoic box
- Effectiveness shielding test
- Antenna measurements
- RF immunity test applications
The H20, H10, H5, and E5 are magnetic field (H) and electric field (E) probes for radiated emissions EMC pre-compliance measurements. The probes are used in the near field of sources of electromagnetic radiation. They serve to locate and identify potential sources of interference within the building blocks of electronic assemblies. The probes act similar to wide bandwidth antennas, picking up radiated emissions from components, PCB traces, housing openings or gaps, and from any other parts that could be emitting RF. The probes are usually connected to a spectrum analyzer. Scanning the probe over the surface of a PCB assembly or housing quickly identifies locations that emit electromagnetic radiation. By changing to a probe with a smaller size, the origination of the emissions can be further narrowed down.
EMC SHAC-200, 700MHz-40GHz
- 5G applications
- Full Anechoic box
- Effectiveness shielding test
- Antenna measurements
- RF immunity test applications
- (L)222x(W)110x(H)110 cm (+H 70cm trolley)
The ESD-Sense has been developed with EMC test laboratories in mind to enable a “go / no-go” verification of the ESD generator output prior to test.
Diode Pulse Limiter with built-in 10 dB high power attenuator and fuse lamp to protect sensitive measuring equipment when measuring spectra with high energy. Thanks to the built-in fuse lamp, serious overload situations of sensitive equipment can be recognized fast and reliably. A replacement bulb is placed inside the unit. The pulse limiter prevents expensive equipment defects. The very flat frequency response allows high measurement accuracy, even if only a few sample values are used for correction.
Diode Pulse Limiter with built-in 20 dB high power attenuator and fuse lamp to protect sensitive measuring equipment when measuring spectra with high energy. Thanks to the built-in fuse lamp, serious overload situations of sensitive equipment can be recognized fast and reliably. A replacement bulb is placed inside the unit. The pulse limiter prevents expensive equipment defects. The very flat frequency response allows high measurement accuracy, even if only a few sample values are used for correction.
