Standards

Products

CAP 0.9-400, 0.9 µF capacitor for NNHV 8123-400/-800

In order to be compliant to the standards ECE R10.06, CISPR 12 and PSA (which require a capacitance of in total 1 uF parallel to a resistance of 1 MΩ at the input side of the LISN) a 0.9 μF capacitor like the CAP 0.9-400 has to be connected to the mains terminals of the NNHV 8123-400 or NNHV 8123-800 LISN.

CAP 10-100 & CAP 10-200, 10 µF Capacitor for DO-160 and DEF-STAN-59

To be compliant to the standards DEF STAN 59 and DO 160 a 10 μF capacitor like the CAP 10 has to be connected to the mains connectors of the LISN.

SYMAT 40, Symmetrical Step Attenuator, 100 Ohms acc. EN 50561-1

  • Symmetrical 100 Ω step attenuator
  • Switchable between 0 dB, 10 dB, 20 dB, 30 dB, 40 dB and 50 dB
  • For measurement of PLC or PLT to discover dynamic performance
  • Acc. EN 50561-1:2012 chapter 9.2. Figure 4 shows the setup

ISN 50561-1, ISN for PLC measurement, acc. EN 50561-1

  • Impedance stabilization network (ISN)
  • For measurements of asymmetrical disturbance voltage of power line communication equipment
  • Acc. standard EN 50561-1:2012, Annex B, Figure B.1.

NTFM 8131, ISN for 2 unshielded Unsymetrical lines, Acc CISPR 32

  • T-ISN 150 Ohm asymmetric
  • BNC-jack 50 Ohm unsymmetric
  • 2-wire
  • 400 V, 3 A AC
  • 9 kHz - 30 MHz
  • CISPR 22 D1, EN55015-2002, CISPR 32, CISPR 15

IGUF 2910 S, High Power Pulse Generator

  • Small battery-operated generator
  • Works with all appropriate antennas via 50 - Ohms - Output
  • Standard field generation without problems caused by cables
  • Easy receiver tuning due to broadband-spectrum
  • High pulse repetition frequency gives audible sound
  • Extremely high pulse power: 1.8 kilowatts at 50 Ohms
  • Exceptionally flat spectrum: 300 MHz / - 1 dB, 1 GHz / -6 dB

SG 9301, 1-1000MHz Comb Generator

  • Spectrum Generator
  • 30-1000 MHz
  • spectrum lines switchable 100 Hz, 1 kHz, 10 kHz, 100 kHz, and 1 MHz
  • N-female connector
  • charger ACS 110 required
  • main application: reference radiator (antenna required e.g. UBAA 9114 with BBVU 9135)

SG 9302 D, 0.1 - 18 GHz Comb Generator

  • Spectrum Generator
  • 100 MHz - 18 GHz 
  • spectrum lines 100 MHz (minor adjustment allowed to match up to receiver)
  • SMA-female connector
  • charger Via USB
  • main application: reference radiator requires antenna

SG 9303, 0.01 - 8 GHz Comb Generator

  • Spectrum Generator
  • 10 MHz - 8 GHz 
  • spectrum lines 10 & 100 MHz 
  • N-female connector
  • charger ACS 110 required
  • main application: reference radiator requires an antenna

BBV 9721, 12 - 40 GHz, 35dB Gain, Microwave Broadband Preamplifier

  • Low Noise Amplifier (preamp)
  • (12) 18 GHz - 40 GHz 
  • Typical gain: 35 dB
  • Noise Figure: 5.5 dB


Loading...