Products
The EPS Test Table is a simple, inexpensive solution for your EMI testing. It is made from durable, expanded polystyrene (EPS) material and can be customized to your requirements. Complies with CISPR, ISO, & IEC requirements for having a low permittivity and can be used for additional standards.
- High strength EPS 3lb per ft3
- Low Permittivity >1.04
- Made for high loading 500 lb.
- Options
- vinyl topper with your company logo (shown in picture)
- epoxy coating for the top (can be combined with vinyl)
The Marvell® 88Q1010 solution is a single pair Ethernet physical layer transceiver (PHY). Our optoLAN-88Q1010 is suitable for EMC tests of devices with this kind of chipset. The standard connector is a 4 pole Rosenberger HSD to minimize the emission of our optical link.
The Wood Test Table is a simple, inexpensive solution for your EMC testing. The table is built to be ship flattened to reduce shipping costs and easily assembled on site quickly. The picture is shown with a ground plane.
The Marvell® 88Q1010 solution is a single pair Ethernet physical layer transceiver (PHY). Our optoLAN-88Q1010 is suitable for EMC tests of devices with this kind of chipset. The standard connector is a 4 pole Rosenberger HSD to minimize the emission of our optical link.
Helmholtz Coils Overview see below
Test System for MIL-STD-641 CS114, CS115, CS116
- Automatic calibration for the whole test frequency range
- Application of all test frequencies automatically. The level can be selected or automatic.
- NO need to manually configure the measurement equipment
- NO need to manually integrate the transfer function of probes and attenuators
- Generation of test reports: NO need to record all values read from the measurement equipment
- Generation of calibration reports: NO need to record all calibration setting parameters
- Rack together and add CS101, CS109, and RS101 (sections 18, 19, and 20 of the RTCA DO-160G are also available.)
The optoCAN-FD system can be used for the bidirectional optical transmission of CAN-signals with transmission rates of up to 10 Mbit/s. It consists of two identical battery supplied transceivers connected to each other with an optical fiber. With the optical transmission and the shielded case, the system is well equipped for EMI and EME tests.
The optoLAN-BCM89811 system can be used for the optical transmission of automotive ethernet signals with Broadcom© BCM89811© and other 100BaseT1 chipsets. There are two setups available, T1 to T1 (standard) or T1 to Tx (with integrated media converter => optoLAN-BCM89811 -MC), see separate setup document. The standard connector is Rosenberger HSD (Z-coded).
- Vertikal Active Rod Antenna
- 9 kHz - 30 MHz
- BNC
- reduced noise floor
- with mounting nut for AM 9144 and rechargeable battery
- Meeting requirements of MIL-STD-461, CISPR 25, and others
The optoLAN-100Base-T1
-MAX system can be used for the optical transmission of automotive ethernet signals with NXP© TJA1100© chipset (unshielded twisted pair UTP ethernet). The system can be set up with two identical transceivers or one side automotive ethernet and the other 100BaseT. With this setup, the link can be used as a media converter. The devices are supplied by internal batteries and connected with an optical fiber. The standard connector is a 4 pole Rosenberger HSD.
