The Pulse Voltage Divider PVD 10-2 & PVD 10-3 have been designed to measure the pulse output of surge generators, e.g. a combination wave generators. It consists of the divider and a double-shielded coaxial cable. The measuring cable with the termination network is an essential part of the divider. The termination network can be adjusted for an oscilloscope input impedance of 1 M? // 10 - 30 pF.

The Capacitive Coupling Clamp, EFTC 2012, provides the ability to couple Burst / EFT pulses to data lines. It can also be used for coupling to main lines where no CDN is available, for example, high current lines >200 A.

The capacitive Coupling-/Decoupling Networks CDN 2402/2410 are used in combination with the Multi-CE5 and allows superimposition of surge and burst test pulses to up to four I/O signal lines. The test set-up is suitable for surge immunity testing of electronic systems and devices according to IEC 61000-4-4, IEC 61000-4-5 and IEEE 587.

The capacitive Coupling-/Decoupling Network CDN 2802 is used in combination with the Multi-CE5 & Multi-CE7 and allows superimposition of surge and burst test pulses to up to eight I/O signal lines.

These measuring systems are used for the optical, digital transmission of analog signals:

• 1-16 Channels
• With a resolution of 10 Bit
• maximal analog bandwidth of 100 kHz.

The Surge Sense has been developed with EMC test laboratories in mind to enable a “go / no-go” verification of the surge generator output prior to test.

The Trans Sense has been developed with EMC test laboratories in mind to enable a “go/no-go” verification of the transient generator output prior to the test.

The VDips-Sense has been developed with EMC test laboratories in mind to enable a “go / no-go” verification of the Voltage Dip generator output prior to test.

CISPR 32 Annex C section C.2.2.1 contains a requirement to identify emissions that are intermittent in nature and apply timing criteria to determine if the emission complies with the standard, irrespective of level.

Support arm with balancer for ESD test station

• Support arm with the carriage
• 360 degrees pivotable