Products
- Calibration-Pulse Generator acc. CISPR 16
- For Band A, B, C, D (9 kHz-1000 MHz)
- To calibrate the pulse response of the EMI receiver
- Pulse repetition frequency main generator 0.1 - 200 Hz (aux. generator up to 1 MHz) with IEEE-488 Interface.
- Universal Calibration Pulse Generator
- acc. CISPR 16 for Bands A, B, C, D (9 kHz - 1000 MHz)
- especially for EMI Receiver Tests (Pulse weighting, Overload)
- Signal generator 100 kHz, 1 MHz, 10 MHz, 100 MHz (60 dBµV)
- Pulse Repetition Frequency 0.1 Hz - 200 Hz (20 kHz)
- Output Level adjustable in 1 dB steps
- GPIB-Interface.
PLC bypass according to CISPR 25, Annex E.4.3, Figure E.7. Can be used in AC and DC systems.
This is for JLR-EMC-CS V1.0 Amendment 4 test CI 250. This provides the millisecond / sub-millisecond timing pulses over a 60 s period for each of the four required test sequences for the CI 250 immunity to ground offset test. It feeds directly into the "Trigger In" on the arbitrary waveform generator to produce the required transient trigger sequence.
The TBCG3-CN comb generator is primarily designed to verify conducted emission test setups. It is a useful tool to validate the correct operation of the LISN, correct set-up, and correct configuration of the spectrum analyzer.
- 5 kHz-2 GHz,
- switchable 0.1, 0.5, 1, 5, 10 MHz,
- external: 5 kHz-300 MHz,
- 4xNiMH, AA, Charger,
- Country-specific adapter cables DUT socket of the LISN
The TBCP3-1000 is a fixed aperture RF current monitoring probe. It has a very flat response with a 3dB bandwidth of 1 GHz and is characterized and usable over the frequency range from 30kHz to 1 GHz.
The aperture of the RF current monitoring probe is 17 mm. Its transfer impedance is close to 20 dB Ohm in the range from 3 MHz to 1 GHz.
The TBCP4-250, -500, and -750 is a fixed aperture RF current monitoring probe, it has a very flat response with a 3dB bandwidth of 750 MHz and is characterized and usable over the frequency range from 10kHz to 800 MHz. The aperture of the RF current monitoring probe is 32 mm. Its transfer impedance is close to 14 dB Ohm in the range from 400 kHz to 750 MHz.
The TBL5016-2 is a Line Impedance Stabilization Network for the measurement of line-conducted interference within the range of 9kHz to 30MHz, according to the CISPR 16-1-2 standard.
The device is designed for testing single phase, AC-powered equipment with supply voltages up to a maximum 240V and 16A.
The TBL0550-1 5µH LISN is a device required to setup conducted noise measurements of DC-powered electronic equipment. It is designed to be used for measurements in the frequency range of 150kHz to 110 MHz according to CISPR 16-1-2, CISPR-25, EN55025, MIL-STD-461F, ISO11452-4 and with limitations DO-160/ED-14G and ISO 7637-2.
The TBCDN-M2 is a Coupling Decoupling Network for conducted immunity testing according to IEC 61000-4-6. The TBCDN-M2 is compliant with IEC 61000-4-6 Annex D2.
