Products
- Clamp-on Current Clamp
- 0.09 - 80 MHz
- Transfer Impedance: 1 Ohm for wires up to 23 mm
- Clamp-on Current Clamp
- 0.09 - 200 MHz
- Transfer Impedance: 8 Ohm for wires up to 23 mm
- Clamp-on Current Clamp
- 0.09 - 200 MHz
- Transfer Impedance: 8 Ohm for wires up to 23 mm
Transformers
fixtures and adapters to measure filters
ferrites and other passive components.
Detailed product list and data sheets on request.
Buffer network (CISPR 17)
Frequency range: 100 kHz - 30 MHz
max. 32 A
- Calibration-Pulse Generator acc. CISPR 16
- For Band A, B, C, D (9 kHz-1000 MHz)
- To calibrate the pulse response of the EMI receiver
- Pulse repetition frequency main generator 0.1 - 200 Hz (aux. generator up to 1 MHz) with IEEE-488 Interface.
- Universal Calibration Pulse Generator
- acc. CISPR 16 for Bands A, B, C, D (9 kHz - 1000 MHz)
- especially for EMI Receiver Tests (Pulse weighting, Overload)
- Signal generator 100 kHz, 1 MHz, 10 MHz, 100 MHz (60 dBµV)
- Pulse Repetition Frequency 0.1 Hz - 200 Hz (20 kHz)
- Output Level adjustable in 1 dB steps
- GPIB-Interface.
PLC bypass according to CISPR 25, Annex E.4.3, Figure E.7. Can be used in AC and DC systems.
This is for JLR-EMC-CS V1.0 Amendment 4 test CI 250. This provides the millisecond / sub-millisecond timing pulses over a 60 s period for each of the four required test sequences for the CI 250 immunity to ground offset test. It feeds directly into the "Trigger In" on the arbitrary waveform generator to produce the required transient trigger sequence.
The TBCG3-CN comb generator is primarily designed to verify conducted emission test setups. It is a useful tool to validate the correct operation of the LISN, correct set-up, and correct configuration of the spectrum analyzer.
- 5 kHz-2 GHz,
- switchable 0.1, 0.5, 1, 5, 10 MHz,
- external: 5 kHz-300 MHz,
- 4xNiMH, AA, Charger,
- Country-specific adapter cables DUT socket of the LISN
