Standards

Products

ECSS LISN 1, 10 Hz - 150 MHz, 10A, DC Lines, LISN

  • European Cooperation for Space Standardisation -LISN Line Impedance Stabilization Network
  • 10 Hz - 150 MHz
  • Max current 10A, (15A 15min)
  • Impedance of each path: 1.5 μH || 50 Ω

PILOT ISN, 150 kHz - 30 MHz, 1.4A, PLC

  • PLC Power Line Communications, ISN Impedance Stabilization Network
  • 150 kHz - 30 MHz
  • Max current 1.4A, 
  • Impedance of each path: 150 Ω

NNBL 8240, 9 kHz - 100 MHz, 800A, 50µH Single Path LISN

  • Measurement of interference for MIL-STD-461/462
  • 9 kHz - 100 MHz
  • 1000VDC / 650VAC 50/60Hz
  • Max current 800A, (1000A limited time)
  • Impedance of each path: 50 µH +5 Ω || 50 Ω ±20 %

CS-50, 2 way splitter, 50 Ohms acc. EN 50561-1

  • A resistive, unsymmetrical two-way splitter
  • The impedance of 50 Ω
  • Acc. to EN 50561-1:2012 which is explained in chapter 9.2.
  • Figure 4 shows the measurement setup with the available components

SPLIT 100, 2 way splitter, 100 Ohms acc. EN 50561-1

  • A resistive, unsymmetrical two-way splitter
  • The impedance of 100 Ω
  • Acc. to EN 50561-1:2012 which is explained in chapter 9.2.
  • Figure 4 shows the measurement setup with the available components

SY 9223-50561-1, Symmetrical Transformer, 50 to 100 Ohms acc. EN 50561-1

  • Symmetrical transformer
  • Transforms an unsymmetrical 50 Ω signal into a symmetrical signal with an impedance of 100 Ω
  • Attenuates the power by 8 dB
  • Acc. to EN 50561-1:2012, chapter 9.2. Figure 4 shows the setup, figure 5 shows the principle diagram

CU 50561-1, Coupling Unit , acc. EN 50561-1

  • The coupling unit for measurements at powerline transmission devices.
  • Acc. standard EN-50561-1
  • Combined with two-line impedance stabilization networks (LISN) 

AC Separator, acc. EN 50561-1

  • The AC separators provide connectivity between the LISNs and the device under test (DuT) respectively the auxiliary equipment (AE) as well as the connection to the measurement setup.
  • Two of the R/C elements required by the standard EN 50561-1 
  • Built-in (1 M || 100 nF).
  • Two identical AC separators are required 

SW 9602, 10 kHz - 200 MHz Current Transformer

  • Current Transformer
  • Shielded
  • 0.01 - 200 MHz
  • Transfer Impedance: 1 Ohm for wires up to 6.5 mm

SW 9603, 9 kHz - 150 MHz Current Transformer

  • Current Transformer
  • Shielded
  • 0.09 - 150 MHz
  • Transfer Impedance: 1 Ohm for wires up to 14 mm


Loading...