HFRAE 5162 - 0.05 - 30 MHz Receiving HF loop antenna

  • 0.05 - 30 MHz
  • diam. 250 mm
  • 1 Turn
  • Transformer

MARKETS:

TEST STANDARDS:

Data Sheet

SPECIFICATIONS

 

HFRAE 5162 - Passive Magnetic Antennas, RX-Loop Antenna

The Loop Antenna for magnetic fields was designed for medium to high-level field strengths in the frequency range 50 kHz (10 kHz) to 30MHz. The application is without problems due to the passive structure without electronic components or power requirements: H fields from 20 dBμA/m on are indicated with test receivers (50-ohm input, calibration in dBμV) or, with slightly less sensitivity, with spectrum analyzers. Add the log. antenna factor from the table ( k H ) to the dBμV reading of the receiver to obtain the magnetic field strength level in dBμA/m.

For high field-strengths, broadband voltmeters with 50 W input resistance (also power meters - observe overload risks) may be used. Voltage or power readings must be converted to voltage levels in dBμV (20 x log U [μV]). Add the log. antenna factor k H from the calibration table to obtain the magnetic field strength level in dBμA/m

If FAR-FIELD measurements are intended in units of dBμV/m, read the voltage level in dBμV across 50 W and add the E field antenna factor k E from the table (it is 51.5 dB higher and provides the "fictitious E field-level" in dBμV/m ).

Specifications:

  • Frequency Range: 50 kHz ... 30 MHz
  •  Impedance: 50 Ω
  • Magnetic Antenna Factor: typ. 20.5 dB/Ωm
  • Electric Antenna Factor: typ. 72 dB/m
  • Number of turns: 1
  • Loop diameter: 250 mm
  • Terminals: BNC
  • Mount: 3/8"
  • Weight: 400g

 

 

 

OTHER PRODUCTS IN THE SAME CATEGORY:
Loading...