Standards

Products

CDN 10216 & 12216, 2-line, 16 Amp, Surge and EFT/burst, Coupling Decoupling Network

The capacitive Coupling-/Decoupling Network CDN 10216 & 12216 is used in combination with the Surge generators PG 7-250, PG 10-504 or PG 12-804 and allows superimposition of surge test pulses to the single-phase power supply voltage of the device under test. The test set-up is suitable for immunity testing of electronic systems and devices according to IEC 61000-4-4, IEC 61000-4-5 and IEEE 587.

CDN 2402 & CDN 2410, Signal Line, Surge and EFT/burst, Coupling Decoupling Network

The capacitive Coupling-/Decoupling Networks CDN 2402/2410 are used in combination with the Multi-CE5 and allows superimposition of surge and burst test pulses to up to four I/O signal lines. The test set-up is suitable for surge immunity testing of electronic systems and devices according to IEC 61000-4-4, IEC 61000-4-5 and IEEE 587.

CDN 2802, Signal 8-Line, Surge and EFT/burst, Coupling Decoupling Network

The capacitive Coupling-/Decoupling Network CDN 2802 is used in combination with the Multi-CE5 & Multi-CE7 and allows superimposition of surge and burst test pulses to up to eight I/O signal lines.

Ux/14-BNC, 1-16 Channels, 100 kHz, Analog Fiber-optic links

These measuring systems are used for the optical, digital transmission of analog signals:

  • 1-16 Channels
  • With a resolution of 10 Bit
  • maximal analog bandwidth of 100 kHz.

Surge-Sense Quick pre-check of IEC 61000-4-5 Surge

The Surge Sense has been developed with EMC test laboratories in mind to enable a “go / no-go” verification of the surge generator output prior to test.

Trans-Sense Quick pre-check of IEC 61000-4-4 EFT

The Trans Sense has been developed with EMC test laboratories in mind to enable a “go/no-go” verification of the transient generator output prior to the test.

VDips-Sense Quick pre-check of IEC 61000-4-11 Dips

The VDips-Sense has been developed with EMC test laboratories in mind to enable a “go / no-go” verification of the Voltage Dip generator output prior to test.

CISPR 32 Training Jig

CISPR 32 Annex C section C.2.2.1 contains a requirement to identify emissions that are intermittent in nature and apply timing criteria to determine if the emission complies with the standard, irrespective of level.

SESD 30 T 1000 Support arm

Support arm with balancer for ESD test station

  • Support arm with the carriage
  • 360 degrees pivotable

AA 9203 Mast Adapter for Antenna Mast System AM 9144

Mast Adapter for AM 9144 with 22 mm hole for most Antenna models

  • 3/8" and 1/4" camera threads polarisation and
  • elevation continuously adjustable


Loading...