PPS 9208 Pneumatic Polarisation Swivel Adapter 

• Change the polarisation of Antennas with a 22 mm tube
• Swivel on center
• Remote controlled or manually
• Compressed air with a recommended pressure of 5 to 6 bar is required
• Standard 12V 200mA solenoid (options for 24V DC, 24V AC, 110V AC, or 230V AC)

The pneumatic polarisation swivel adapter PPS 9208 is used to change the polarisation of Antennas with a 22 mm tube remote controlled. Compressed air with a recommended pressure of 5 to 6 bar is required. Higher air pressure should be reduced with a pressure regulator.

The control of the 2 way the pneumatic cylinder is performed using a 5/2-way valve, which can be alternated by applying/removing a voltage of 12V or manually by turning the red screw using a screwdriver.

In order to achieve a smooth antenna rotation, flow control valves are used. The flow control valves and the end position damping are set to reasonable values in the factory already. By default, we deliver a 12V 200mA DC operated solenoid (also available: 24V DC, 24V AC, 110V AC, or 230V AC, 2,5 Watt respectively) The airflow control valves and the end position damping are set to reasonable values by the factory

Set up and installation:

Initially the Polarisation Swivel Adapter should be attached to the antenna mast without mounting the antenna itself. For this purpose use the long nut size 24mm. Manual tightening without wrench is usually sufficient. Then connect compressed air to the side of the valve where only one tube can be connected. Apply the designated supply voltage for the solenoid e.g. 12 V DC and watch the reaction! Remove the voltage again! The polarisation should change. The red screw may not be pressed in (position „1“). The red screw is for manual operation and must be in position “0” (=factory setting)

Now the antenna may be placed with its 22 mm tube into the fixture of the PPS 9208.