Products
- Covers 1–18 GHz with programmable frequency steps
- Delivers flat, stable signals with HI/LO output options
- Sequential signal generation for better dynamic range
- Compatible with spectrum analyzers & EMI receivers
- Battery-powered with 8-hour runtime and USB-C charging
- Includes accredited calibration and supports ISO 17025 compliance
By Frequency Range
- High current power stage (uni-directional)
- Up to 32 channels for switching low-current signals (bi-directional)
- Switching of resistive, inductive, capacitive passive, and active loads/devices
- Input voltage up to 100V
- Output current up to 200A DC
The Schwazbeck Biconical elements come in many sizes and offer different performances depending on what your needs are. For best low-frequency performance (good gain, low antenna factor), larger elements work better. The downfall of larger elements is handling or fitting in the test space. Many situations may not need outstanding performance with larger elements. The benefits of these elements and antenna baluns are that they all use the same connections (10mm), allowing for versatile sharing/switching of elements. No need to purchase a new antenna; get new elements.
The CDG 7000 is a new test generator for all standards on immunity to conducted disturbances induced by high-frequency fields - including BCI tests (ISO 11452-4). One of the very few combined IEC 61000-4-6 test systems that contain the RF signal generator, an RF power amplifier, a 3-channel RF voltmeter, and a directional coupler at a very affordable price. IEC 60601-1-2 calling out IEC 61000-4-39 magnetic immunity for close proximity testing requirements can also now be met with the 10 kHz unit.
Absolute EMC has designed low-cost pre-compliance systems to meet a wide range of RF emissions and immunity needs. Some form of pre-complaint testing is a must for any company that needs to demonstrate their product for EMC compliance. This enables companies to be responsive when issues happen and to also be proactive before going to the lab to better your chances of passing the first time.
WaveMaster + AnyWave
BOLAB WaveMaster software and the BOLAB AnyWave control unit allow the control of power supplies as well as 4 quadrant amplifiers via the analog interfaces.
The powerful and easy-to-use BOLAB WaveMaster software is unique in the world. Without any knowledge in software development, designing ordinary and complex waveforms is very easy. A graphic waveform editor allows the generation
of individual curves in no time. Also, with tabular input, all types of waveforms can be produced instantly.
The fiber connector cleaning kit allows for cleansing the fiber optic connector to ensure reliable operation of the LSProbes and other Fiber optic products.
WaveMaster + AnyWave
BOLAB WaveMaster software and the BOLAB AnyWave control unit allow the control of power supplies as well as 4 quadrant amplifiers via the analog interfaces.
The powerful and easy-to-use BOLAB WaveMaster software is unique in the world. Without any knowledge in software development, designing ordinary and complex waveforms is very easy. A graphic waveform editor allows the generation
of individual curves in no time. Also, with tabular input, all types of waveforms can be produced instantly.
- DC - 200 kHz bandwidth DC
- MHz (small signal -3 dB)
- Output voltage ±75 Vpk
- Rise / fall time 100 V/µs
- USB interface standard, LAN optional
- Analog control input 0 ... ±10 V for control of voltage and current
- Monitor outputs for measured voltage and current values (not all models)
- Modularly extensible via master-slave mode
- Parallel and Series Connections for two or more units
