Products
The TBTP1 tripod is a lightweight, compact tripod made out of carbon fiber and is suitable for all EMC antennas up to 6kg.
The TBMA6-P is a passive Loop Antenna for affordable EMC pre-compliance testing. It has a frequency range of 9 kHz – 30 MHz, according to CISPR 16.
The optoUSB-2.0-RBDIR system can be used for the optical transmission of USB-signals up to a data rate of 480 Mbit/s according to USB2.0. It can be used to transmit USB-signals over long distances or to handle ground potential problems. With the optical transmission and the shielded case, the system is well equipped for EMI and EME tests.
- optoUSB2.0-RBDIR uses a Rosenberger connector which has been proven to be more EMI robust)
- See Replacement optoUSB2.0 -VA6K
- optoUSB2.0 USB hub with 4 USB ports (not as EMI robust as -RBRIR version)
- optoUSB3.0 USB hub with 2 USB ports (not as EMI robust as 2.0-RBRIR version)
The TBL5016-1 50µH LISN is a device required to setup conducted noise measurements of DC or AC-powered electronic equipment. It is designed according to CISPR 16-1-2 and MIL-STD-461F standard and characterized in the frequency range of 9kHz to 100 MHz.
The TBL5016-3 is a Line Impedance Stabilization Network for the measurement of line-conducted interference within the range of 9 kHz to 30MHz, according to the CISPR 16-1-2 standard. The device is designed for testing 3-phase and single-phase, AC-powered equipment with supply voltages up to a maximum 450V/260V and 16A.
The TBL5032-3 is a Line Impedance Stabilization Network for the measurement of line-conducted interference within the range of 9 kHz to 30MHz, according to the CISPR 16-1-2 standard. The device is designed for testing 3-phase and single phase, AC-powered equipment with supply voltages up to maximum 450V/260V and 32A.
The TBL50100-1 50µH is a single channel 50 ohm // 50 µH LISN for the frequency range 150 kHz – 30 MHz according to CISPR 16-1-2. In addition to conducted noise measurements on AC or DC supplied equipment, the LISN can be used to establish a defined impedance for a variety of other standardized tests.
The TBGTC1 open GTEM-cell is a low-cost cell for EMC pre-compliance immunity and emissions testing. Unlike TEM cells, which have limits at higher frequencies, the TBGTC1 GTEM cell may operate up to 6GHz.
The TBTP3 tripod, made out of beech wood, is suitable for most of our antennas up to 8kg.
- Safely connect wires to CDN Mains, 63A and 125A
- outer conductor -Ø from 10,5mm up to 18,5mm
- Multi-Contact 6mm
