Standards

Products

The TBPCP1-20100 is a RF pulse current monitoring probe with a very flat response from 20 Hz to 100 MHz and is characterized over the frequency range from 1 Hz to 200 MHz.

The TBPCP2-3070 is a RF pulse current monitoring probe with a very flat response from 30 Hz to 70 MHz and is characterized over the frequency range from 1 Hz to 200 MHz. 

The TBSCP1-5M300 is a RF surface current monitoring probe with a very flat response from 5 MHz to 300 MHz and is characterized over the frequency range from 30 kHz to 400 MHz.

The TBSCP1-10M500 is a RF surface current monitoring probe that has a very flat response from 10MHz to 500 MHz and is characterized over the frequency range from 30 kHz to 600 MHz. 

The TBATTs are DC - 3GHz attenuators available with 3 - 30dB attenuation in 10-100W versions.  N male to N female connections.

TBTER-50 Ohm RF Terminations from 0.5W to 25W

  • Low Noise Amplifier (preamp)
  • 10 MHz - 8 GHz  
  • Typical gain: 29 dB
  • Noise Figure: 2.7 dB

list of current equipment available from inventory. 

The TBFL1 is a combined transient limiter/attenuator/ high pass filter, designed to provide optimum protection of spectrum analyzer or measurement receiver inputs when carrying out conducted noise measurements or other measurements where the input levels cannot be predicted with certainty or where accidental overloads may occur.

The CAR arbitrary waveform generator 3000 is a compact EMC testing system for performing voltage variations on supply lines of vehicles. The system strictly complies with the international standards and manufacturer standards that describe phenomena on the power supply of vehicles. Thus, the CAR arbitrary waveform generator 3000 is the optimal voltage power source for battery simulation up to 70V. It can simulate pulse 2b, pulse 4, starting profile, superimposed alternating voltage and others, up to a battery current of 100A.

Loading...