Products
EMCL- NW 10 / MN-1 Matching Network • For use with the EMCL-20 in the frequency range 10 kHz – 150 kHz • For use with the CDN BCI-P1 in the frequency range 10 kHz – 150 kHz
The VUSLP 9111 F is a demountable log-periodic antenna
- 75 - 4000 MHz
- 1 kW
- Type N (female)
Pneumatic polarisation shifter with a 2-way pneumatic cylinder for all Schwarzbeck antennas with a 22 mm tube on AM 9144. Compressed air required.
The Antenna Hinge Joint is a device made of high-grade insulating material to change the polarisation of large preferably double-boom antennas such as LOG-PER models.
Positioner for lightweight antennas like SBA 9113 with 420 NJ. The positioner consists of 1 piece of glass fiber tube 22 mm thick, 1000 mm long, an adapter AA 9203 is mounted to the tube. The other end of the tube carries a 3/8 inch male camera thread.
Adapter for Schwarzbeck antennas with 22 mm tube on EMCO mast.
Swivel handle for light antennas
The USLP 9142 is a log-periodic antenna
- 0.7 - 8 GHz
- 50 W
- Type N (female)
A non-metallic mast adapter for most lightweight Antenna models with 22 mm tube minimizes reflections
- 3/8" camera thread
- polarisation continuously adjustable
The H20, H10, H5, and E5 are magnetic field (H) and electric field (E) probes for radiated emissions EMC pre-compliance measurements. The probes are used in the near field of sources of electromagnetic radiation. They serve to locate and identify potential sources of interference within the building blocks of electronic assemblies. The probes act similar to wide bandwidth antennas, picking up radiated emissions from components, PCB traces, housing openings or gaps and from any other parts that could be emitting RF. The probes are usually connected to a spectrum analyzer. Scanning the probe over the surface of a PCB assembly or housing quickly identifies locations which emit electromagnetic radiation. By changing to a probe with a smaller size, the origination of the emissions can be further narrowed down. With TBWA2 WIDEBAND AMPLIFIER/20DB
