Standards

The EPS Test Table is a simple, inexpensive solution for your EMI testing. It is made from durable, expanded polystyrene (EPS) material and can be customized to your requirements. Complies with CISPR, ISO, & IEC requirements for having a low permittivity and can be used for additional standards.

• High strength EPS 3lb per ft³
• Low Permittivity >1.04
• Made for high loading 500 lb.
• Options
• vinyl topper with your company logo (shown in picture)
• epoxy coating for the top (can be combined with vinyl)

• Modular construction
• Electronically and mechanically (+ life time counter) triggerable load switches
• Artificial Network with temperature control
• Shunt resistors: 10 / 20 / 40 / 120Ω
• Battery current: 50A / 100A

The Absolute EMC106 series of cables is a very high-performing Coax operating up to 18GHz with incredibly low losses. It can be used for high-power applications resulting in more power reaching your antenna. Also ideal for emissions testing up to 18GHz. allowing for long-distance runs with less loss. 

CABCISPR2532A

• TEST STANDARD: CISPR 25
• 5 μH // 50 Ω LISN / Artificial Network
• Small Size 80 x 80 x 120mm

CABCISPR2515A

• TEST STANDARD: CISPR 25
• 5 μH // 50 Ω LISN / Artificial Network
• Small Size 35 x 80 x 120mm

The Absolute Coax series of cables are designed specifically to meet the requirements for EMC testing. Each industry has requirements that are unique. EMC is no different. Absolute EMC has gone through the selection process to only offer the best performance quality and value. Taking away the need to spend hours searching and looking through specs and manufacturers to find what you hope is the best value. 4 options are available fitting most EMC applications.

Test System for MIL-STD-641 CS114, CS115, CS116

• Automatic calibration for the whole test frequency range
• Application of all test frequencies automatically. The level can be selected or automatic.
• NO need to manually configure the measurement equipment
• NO need to manually integrate the transfer function of probes and attenuators
• Generation of test reports: NO need to record all values read from the measurement equipment
• Generation of calibration reports: NO need to record all calibration setting parameters
• Rack together and add CS101, CS109, and RS101 (sections 18, 19, and 20 of the RTCA DO-160G are also available.)

The optoCAN-SW system can be used for the optical transmission of single-wire CAN signals with transmission rates of up to 33kbit/s (max. 83kbit/s). It optical transmitter of single-wire CAN signals: optoCAN-SWconsists of two identical battery supplied transceivers connected to each other with an optical fiber. With the optical transmission and the shielded case, the system is well equipped for EMI and EME tests.

• Technologically advanced, fast-switching, compact 19-inch power supplies
• High control dynamics in the 100...200 µs range – even at higher power levels
• Exceptional current accuracy of <0.02% FS, additional high-resolution current measurement range included as standard
• Full power regeneration and a high degree of efficiency, resulting in a significant reduction of energy consumption and heat dissipation, low acoustic noise
• Wide current-voltage range with an auto-ranging factor of 3
• Full digital CV, CC, CP, CR, and Ri-Sim control modes

The optoCAN-HS system can be used for the bidirectional optical transmission of CAN signals with transmission rates of up to 1Mbit/s. It consists of two identical battery-supplied transceivers connected to each other with an optical fiber. The optical transmission and the shielded case make the system well equipped for EMI and EME tests. The optoCAN-FD is fully backward-compatible with HS and is highly recommended.