Categories

CISPR 16-1-1

OTHER PRODUCTS IN THE SAME STANDARD:
DGA 9552 N, Attenuator, 5 watts, 18GHz, 3, 6, 10, 20, 30, & 40dB

DGA 9552 N is a bidirectional attenuator, i.e. the attenuation and power capability specification is valid for both directions.

There is a large variety of applications for this attenuator: The measuring range of a spectrum analyzer can be increased. Any kind of meter can be protected against overload; it can be used to control the linearity of a meter reading. It can minimize measurement uncertainty caused by mismatched impedances. During an EMI receiver calibration, an attenuator directly at the pulse generator output is inevitable.

  • 3, 6, 10, 20, 30, and 40 dB Values available
  • 50 Ohm, Low VSWR
  • 5 Watts, 1 kW peak (5 μsec. pulse width, 0.25% duty cycle)
  • Optional storage case CCA

DGA 9553 BNC, Attenuator, 1 watts, 2GHz, 3, 6, 10, 20, and 30 dB

DGA 9553 BNC is a bidirectional attenuator, i.e. the attenuation and power capability specification is valid for both directions.

There is a large variety of applications for this attenuator: The measuring range of a spectrum analyzer can be increased. Any kind of meter can be protected against overload; it can be used to control the linearity of a meter reading. It can minimize measurement uncertainty caused by mismatched impedances. During an EMI receiver calibration, an attenuator directly at the pulse generator output is inevitable.

  • 3, 6, 10, 20, and 30 dB Values available
  • 50 Ohm, Low VSWR
  • 1 Watts

BBHA 9170 - 15-40 GHz Horn Antenna

Broad-Band Horn Antenna

  • 15 - 26.5 (40) GHz
  • SMA-compatible connector

EMC EPS 5cm Sheets - low permittivity EUT Support for high frequency testing

The original EMC EPS 5CM Sheets are white Expanded Polystyrene with 1cm x 1cm indentations for easy measurements. It can be cut down to size with the included razor knife. Keep your test setup looking professional with these lightweight and soft EUT supports. Ideal for the use in EMC testing for EUT and cable supports. The EMC EPS 5CM SHEETS are crush resistance able to withstand heavy weight loads without deforming. 1cm marking on the top side allows for easy positioning and test setups. Conveniently sold as sheets other sizes possible just ask. 

MDS 21 C, 30 - 1000 MHz, EMI Absorbing Clamp

  • EMI Absorbing Clamp
  • 30 - 1000 MHz
  • acc. CISPR 16 for interference power with silicon-coated rolls
  • Also for shielding measurements on coax. cables

TBMR-110M DC - 110 MHz high speed EMI-Analyzer

The TBMR-110M EMI Analyzer is designed to carry out conducted emission measurements. Its affordability and versatility make it a perfect tool for engineers doing pre-compliance measurements during the development process.
  • True DC – 110 MHz measurement range
  • CISPR-16, ANSI and MIL-STD compliant detectors
  • Peak, Quasi-Peak, Average, CISPR Average, RMS and CISPR RMS dectectors working in parallel
  • Zero Span operation with time domain triggering
  • Linear, log amplitude and frequency display

Loading...