• EMC EPS 5cm Sheets - low permittivity EUT Support for high frequency testing

EMC EPS 5cm Sheets - low permittivity EUT Support for high frequency testing

The original EMC EPS 5CM Sheets are white Expanded Polystyrene with 1cm x 1cm indentations for easy measurements. It can be cut down to size with the included razor knife. Keep your test setup looking professional with these lightweight and soft EUT supports. Ideal for the use in EMC testing for EUT and cable supports. The EMC EPS 5CM SHEETS are crush resistance able to withstand heavy weight loads without deforming. 1cm marking on the top side allows for easy positioning and test setups. Conveniently sold as sheets other sizes possible just ask. 

PARTNER:

MARKETS:

TEST STANDARDS:

Data Sheet

SPECIFICATIONS

EMC EPS 5cm Sheets

 

The original EMC EPS 5CM Sheets are white Expanded Polystyrene with 1cm x 1cm indentations for easy measurements. It can be cut down to size with the included razor knife. Keep your test setup looking professional with these lightweight and soft EUT supports. Ideal for the use in EMC testing for EUT and cable supports. The EMC EPS 5CM SHEETS are crush resistance able to withstand heavy weight loads without deforming. 1cm marking on the top side allows for easy positioning and test setups. Conveniently sold as sheets other sizes possible just ask.

 

Use EMC EPS 5CM Sheets for ISO/SAE, IEC, MIL-STD, DO160 testing. Has stable dielectric properties better than wood not can retaining moisture, giving better results for testing. 

 

 Specifications:

Material:

Expanded Polystyrene (EPS)

Relative Permittivity:

εr = 1.06

Sheet Sizes:

8’ x 4’ (2438 x 1219mm) ±5% 

8’ x 2’ (2438 x 610mm) ±5%

  Dielectric Strength: 

2kV/mm

Thickness:

50mm ±2%

Volume Resistivity: 

4x1013 ohm-cm

Included:

Utility Knife

Minimum Density:

3.00 lb/ft³ (48 kg/m³)

Other:

1cm marking on 1 side

Mounting:

fits on 1" wood Dowel or tube

 

 

Compressive Strength:

60.0 psi (414 kPa)

 

 

Flexural Strength, min.:

75.0 psi (517 kPa)

 

Stack for EUT supports or use for cable supports for each different requirement

 

The standards allow for a distance measurement tolerance of 10% to 5%. 
 
OTHER PRODUCTS IN THE SAME CATEGORY:
Loading...