" An RF Probe Kit on Steroids"

• Fully integrated with Y.I.C. Technologies EMViewer software and EMProbe
• Normalization and correction when using the EMViewer software
• Flat response within the range of operation
• Slim Design and Protective Coating
• 18GHz Measured Cable included
• Lectures & Explanation Document
• Designed By Prof. Arturo Mediano, University of Zaragoza, Spain

• See EMI instantly with real-time 150 kHz–6 GHz emissions mapping
• Pinpoint noise sources fast using a dense 1,218-probe near-field array
• No external instruments required — integrated spectrum analyzer built in
• Validate fixes in seconds, not hours or days
• Cut compliance risk and testing time with bench-top pre-compliance diagnostics

• See EMI instantly with real-time 150 kHz–6 GHz emissions mapping
• Pinpoint noise sources fast using a dense 1,218-probe near-field array
• No external instruments required — integrated spectrum analyzer built in
• Validate fixes in seconds, not hours or days
• Cut compliance risk and testing time with bench-top pre-compliance diagnostics

The broadband horn antenna BBHA 9120 L is a linear polarized double-ridged horn antenna.

• 3 GHz to 40 GHz.
• 2.92 mm - female

DGA 9552 N is a bidirectional attenuator, i.e. the attenuation and power capability specification is valid for both directions.

There is a large variety of applications for this attenuator: The measuring range of a spectrum analyzer can be increased. Any kind of meter can be protected against overload; it can be used to control the linearity of a meter reading. It can minimize measurement uncertainty caused by mismatched impedances. During an EMI receiver calibration, an attenuator directly at the pulse generator output is inevitable.

• 3, 6, 10, 20, 30, and 40 dB Values available
• 50 Ohm, Low VSWR
• 5 Watts, 1 kW peak (5 μsec. pulse width, 0.25% duty cycle)
• Optional storage case CCA

DGA 9553 BNC is a bidirectional attenuator, i.e. the attenuation and power capability specification is valid for both directions.

There is a large variety of applications for this attenuator: The measuring range of a spectrum analyzer can be increased. Any kind of meter can be protected against overload; it can be used to control the linearity of a meter reading. It can minimize measurement uncertainty caused by mismatched impedances. During an EMI receiver calibration, an attenuator directly at the pulse generator output is inevitable.

• 3, 6, 10, 20, and 30 dB Values available
• 50 Ohm, Low VSWR
• 1 Watts