Support arm with balancer for ESD test station

• The only support arm is made from non-metal 
• 1.5" Fiberglass Tubes,
• 3D Printed: Cage, holder, base
• Custom ESD simulator adaption
• Balancer is plastic housing and string (only the spring is metallic)
• Only the system meets the metal-free area requirements of standards
• Support arm with the carriage
• 360 degrees pivotable
• Customized attachment to the table included

An 8 kV ESD simulator for contact and air discharge testing, with a built-in camera and a 3.5-inch color touchscreen. See the discharge point live and save images before and after an impulse to support test documentation.

The portable ESD gun includes a 150 pF / 330 ohm RC network, two rechargeable battery packs and USB-C charging. Increase the voltage capability later with a purchased unlock code for a higher-voltage ONYX VISION configuration.

An 16 kV ESD simulator for contact and air discharge immunity testing. Its integrated 1.5-megapixel camera displays the test point on a 3.5-inch color touchscreen and saves photographs before and after an impulse.

Includes a 150 pF / 330 ohm RC network, two rechargeable batteries and USB-C charging. Upgrade to 30 kV later with a purchased unlock code.

A 30 kV ESD simulator for contact and air discharge immunity testing. Its integrated 1.5-megapixel camera displays the test point on a 3.5-inch color touchscreen and saves photographs before and after an impulse.

Includes a 150 pF / 330 ohm RC network, two rechargeable batteries and USB-C charging. The 30 kV model provides the highest listed family voltage; lower-voltage models can be upgraded with a purchased unlock code.

The ESD Test Table Kit is a simple inexpensive solution for your ESD testing. Complies to the requirements of IEC 61000-4-2 and can be used for additional standards. Comes with a Horizontal Coupling Plane (HCP), resistive cable to tie HCP to floor ground plane, bleeder wire for discharging ungrounded battery powered EUTs, 0.05mm insulator and an alternative low impedance ground for using the table for additional setups such as IEC 61000-4-6 requirements.

ESD - Generators verified according to the standard International Electro technical Commission 61000-4-2, ISO 10605 and other. The measurements of the single pulses take place with a special 2 ohm shunt. For the correct verification of the ESD impulses an oscilloscope is necessary with a minimum bandwidth of - 2 GHz acc. IEC 61000-4-2, 2008 and - 1 GHz acc. ISO 10605, 2008. The ESD verification set SESD 8800-4 works up to 4 GHz and fulfilled the request of the double bandwidth regarding to the measurement bandwidth.

2m Grounding cable for ESD immunity tests

The Vertical Coupling Plate (VCP) is used in conjunction with ESD generators to simulate indirect discharges on metallic objects that are near a test object. The bleeder resistors contained in the ground wire of the VCP serve to prevent the applied charge from vanishing immediately after the discharge of the ESD generator to the VCP, thereby increasing the effect of the ESD test.

Avalible ESD Test Tips for replacment or different aplications.

Support arm with balancer for ESD test station

• Support arm with the carriage
• 360 degrees pivotable

The ESD-Sense has been developed with EMC test laboratories in mind to enable a “go / no-go” verification of the ESD generator output prior to test.

The TBESDT1 ESD-Target is a current sensing transducer to verify ESD-Simulators. It is used to take measurements compliant with IEC 61000-4-2 up to 4 GHz.