TBBCI1-300K420-HV Snap-On High-Voltage Bulk Current Injection Probe
Snap-On High-Voltage Bulk Current Injection Probe
- RF injection up to 400 MHz
- 10 kHz–500 MHz characterization in the specification table
- Up to 350 mA for customer-defined severity V
- 5 kV pulse injection in the specified DO-160 Section 22 setup
- 27 mm aperture; BNC-SHV male
MARKETS:
CATEGORIES:
TEST STANDARDS:
Cal Adapter Manual
TBBCI1-300K420-HV Manual
SPECIFICATIONS
TBBCI1-300K420-HV Snap-On High-Voltage Bulk Current Injection Probe
Use for bulk current injection on harnesses and RF current monitoring. TekBox lists ISO 11452-4, MIL-STD-461 CS114, GJB 151B and DO-160 Section 20. The 5 kV figure applies to the specified damped sinusoidal pulse setup. Use the individual measurement protocol for frequency-dependent correction and check the required level against the test setup.
Technical specifications
- RF injection up to 400 MHz
- 10 kHz–500 MHz characterization in the specification table
- Up to 350 mA for customer-defined severity V
- 5 kV pulse injection in the specified DO-160 Section 22 setup
- 27 mm aperture; BNC-SHV male
- 5 dB typical insertion loss; 29 dBΩ typical transfer impedance (100 Ω loop)
- 80 °C maximum core temperature; 92 mm diameter × 76 mm high; 1.2 kg
OTHER PRODUCTS IN THE SAME CATEGORY:
TBCP2-250/500/750/30k400 Clamp on RF Current Monitoring Probes
TBCCP1-400K600 COAXIAL RF CURRENT MONITORING PROBE
TBCP3-1000 RF Current Monitoring Probe
TBCP4-250/500/750 RF Current Monitoring Probe
TBBCI1-200K280, 10 kHz – 300 MHz, Snap-On Bulk Current Injection Probe
TBBCI1-800K420, 10 kHz to 500 MHz, Snap-On Bulk Current Injection Probe
TBCCP1-2K70 COAXIAL RF CURRENT MONITORING PROBE
TBCCP1-3K100 COAXIAL RF CURRENT MONITORING PROBE
TBPCP1-20100 PULSE CURRENT MONITORING PROBE
TBPCP2-3070 RF PULSE CURRENT MONITORING PROBE
TBSCP1-5M300 RF SURFACE CURRENT MONITORING PROBE
TBSCP1-10M500 RF SURFACE CURRENT MONITORING PROBE
ACTIVE DIFFERENTIAL PROBES up to 7kV
TBBCI1-300K420-HV Snap-On High-Voltage Bulk Current Injection Probe
TekBox TBCP5-150K400 Snap-On RF Current Monitoring Probe
EMSCOPE, 9kHz - 110MHz, 2 channel Receiver/LISN
EMSCOPE-RX2, 9kHz - 110MHz, 2 channel Receiver
EMSCOPE-RX4, 9kHz - 110MHz, 4 channel Receiver for 3 phase
AB-Precompliant Test Kits
