Support arm with balancer for ESD test station

• The only support arm is made from non-metal 
• 1.5" Fiberglass Tubes,
• 3D Printed: Cage, holder, base
• Custom ESD simulator adaption
• Balancer is plastic housing and string (only the spring is metallic)
• Only the system meets the metal-free area requirements of standards
• Support arm with the carriage
• 360 degrees pivotable
• Customized attachment to the table included

Onyx 16

• +/- 16kV air and Contact Discharge
• 150pF/330Ohm Standard, Other networks available
• >16 hour Battery life, AC mains option
• Optional Software

Onyx 30

• +/- 30kV air and Contact Discharge
• 150pF/330Ohm Standard, Other networks available
• >16 hour Battery life, AC mains option
• Optional Software

The ESD Test Table Kit is a simple inexpensive solution for your ESD testing. Complies to the requirements of IEC 61000-4-2 and can be used for additional standards. Comes with a Horizontal Coupling Plane (HCP), resistive cable to tie HCP to floor ground plane, bleeder wire for discharging ungrounded battery powered EUTs, 0.05mm insulator and an alternative low impedance ground for using the table for additional setups such as IEC 61000-4-6 requirements.

ESD - Generators verified according to the standard International Electro technical Commission 61000-4-2, ISO 10605 and other. The measurements of the single pulses take place with a special 2 ohm shunt. For the correct verification of the ESD impulses an oscilloscope is necessary with a minimum bandwidth of - 2 GHz acc. IEC 61000-4-2, 2008 and - 1 GHz acc. ISO 10605, 2008. The ESD verification set SESD 8800-4 works up to 4 GHz and fulfilled the request of the double bandwidth regarding to the measurement bandwidth.

2m Grounding cable for ESD immunity tests

The Vertical Coupling Plate (VCP) is used in conjunction with ESD generators to simulate indirect discharges on metallic objects that are near a test object. The bleeder resistors contained in the ground wire of the VCP serve to prevent the applied charge from vanishing immediately after the discharge of the ESD generator to the VCP, thereby increasing the effect of the ESD test.

Avalible ESD Test Tips for replacment or different aplications.

ESD Simulator Stand

• Easily and safely put the ONYX 16 or 30 ESD simulator in an upright position
• 2 holders for Air Discharge & Contact Discharge Tips when not in use
• Firmly holds the base and will not allow the simulator to tip. 
• Easy grab-and-go

Support arm with balancer for ESD test station

• Support arm with the carriage
• 360 degrees pivotable

IEC / EN 61000-4-2 The test generator SESD 230 simulates electrostatic discharge as defined in the standard IEC / EN 61000-4-2. Depend on the Equipment Under Test (EUT) and the test set-up for laboratory tests the IEC standard shows two test methods; Test voltage max. 30,0 kV AIR und CON; Discharge impedance 150pF/330 Ohm (IEC); Battery or mains operation; Predefined tests, standard and other

IEC / EN 61000-4-2 The test generator SESD 216 simulates electrostatic discharge as defined in the standard IEC / EN 61000-4-2. Depend on the Equipment Under Test (EUT) and the test set-up for laboratory tests the IEC standard shows two test methods; Air discharge (AIR) and Contact discharge (CON); Test voltage max. 16,5 kV AIR, max. 10,0 kV CON; Discharge impedance 150pF/330 Ohm (IEC); Battery or mains operation; Predefined tests - standard and other