Support arm with balancer for ESD test station

• The only support arm is made from non-metal 
• 1.5" Fiberglass Tubes,
• 3D Printed: Cage, holder, base
• Custom ESD simulator adaption
• Balancer is plastic housing and string (only the spring is metallic)
• Only the system meets the metal-free area requirements of standards
• Support arm with the carriage
• 360 degrees pivotable
• Customized attachment to the table included

The ESD Test Table Kit is a simple inexpensive solution for your ESD testing. Complies to the requirements of IEC 61000-4-2 and can be used for additional standards. Comes with a Horizontal Coupling Plane (HCP), resistive cable to tie HCP to floor ground plane, bleeder wire for discharging ungrounded battery powered EUTs, 0.05mm insulator and an alternative low impedance ground for using the table for additional setups such as IEC 61000-4-6 requirements.

• High input impedance ≥ 100 G Ohm
• Wide measurement ± 1V ~ 100 kV
• High accuracy and resolution ± 1% ± 2 counts
• Portable with large LCD/LED display 4 ½ Digit LCD
• Battery or AC supply
• Measure DC up to 100kV

ESD Simulator Stand

• Easily and safely put the ONYX 16 or 30 ESD simulator in an upright position
• 2 holders for Air Discharge & Contact Discharge Tips when not in use
• Firmly holds the base and will not allow the simulator to tip. 
• Easy grab-and-go