EMI Receiver

The TBMR-110M EMI Analyzer is designed to carry out conducted emission measurements. Its affordability and versatility make it a perfect tool for engineers doing pre-compliance measurements during the development process.

• True DC – 110 MHz measurement range
• CISPR-16, ANSI and MIL-STD compliant detectors
• Peak, Quasi-Peak, Average, CISPR Average, RMS and CISPR RMS dectectors working in parallel
• Zero Span operation with time domain triggering
• Linear, log amplitude and frequency display

Mains Harmonics Current Coupler

Mains-current coupler for measuring harmonic currents with compatible analyzers and measurement setups.

• Mains voltage range: 100 V – 120 V / 200 V – 240 V; mains voltage selection switch
• Max. mains current: 16 A, depending on country specific mains output socket
• Transducer factor: 50 mV/A with 50 Ohm load resistor (DC coupled)
• Mains input socket: C19, 16 A
• Mains output socket: country specific; CEE7/3 16 A (Schuko), NEMA 5-15 15 A, AS/NZS 3112:201 15 A, BS1363, 13A

0.1 Hz – 6 GHz Vector Network Analyzer

Two-port vector network analyzer covering very low frequencies through 6 GHz for component and network characterization.

• 0.1 Hz – 6 GHz Vector Network Analyzer
• 0.001 Hz – 500 MHz Bode Analyzer (requires Bode Hardware Option)
• Signal generator 0.1 Hz – 6 GHz with 0.1 Hz resolution
• Four-channel 60 MHz digital oscilloscope with 125 MS/s and 14-bit resolution. (Two 50 ohm inputs, two 1 megohm inputs)
• Two-Channel DC – 6 GHz spectrum analyzer, with an unambiguous frequency range of DC – 60 MHz and an active sideband suppression for spurious-free signal measurements up to 6 GHz (under certain conditions) and a cross-correlation option. (Input channels can be among all 4 input ports)