Transient Generator

Audio Transformer 200W, 50A

• 160x155x200mm
• 2:1 ratio 
• 200 W Maximum30Hz - 250 kHz
• 100 W Maximum at15 Hz - 30 Hz
• Insulation Resistance Test - 2kV

CABCISPR2532A

• TEST STANDARD: CISPR 25
• 5 μH // 50 Ω LISN / Artificial Network
• Small Size 80 x 80 x 120mm

The Conformity Assessment Business Model DCS06 Test Generator has been designed to operate with its complementary injection clamp to fully meet the pulse requirements of DCS06 when tested into a 5? load. It operates from an intuitive touch screen interface and has full phase synchronization up to 800 Hz input frequency with 1-degree steps. It has been designed with future revisions of the test standard in mind.

The Conformity Assessment Business Model DCS12 Test Generator meets all the DCS12 wave verification parameters for testing DC, single and three-phase equipment, that is source impedance and verification of damping and frequency when measured into a 10 Ω load. Output amplitude is software adjustable with permanent memory, should re-alignment be needed during calibration. 

• There are three fixed outputs: 600 V, 750 V, and 2500 V
• 15.9 kHz ±10 %
• 10.9 kHz ±10 %

Static Dissipation Brush is designed to meet section 7.2.4.1 of EN 61000-4-2: 2009. It is used to dissipate the charge on ungrounded equipment being tested. 

The Conformity Assessment Business Model DCS05 Test Generator. When coupled to its matched test clamp, the Generator produces damped oscillatory wave transients in the frequency range 500kHz to 50 MHz that meet the definition of a type 1N Generator verification requirements Defence Standard 59-411.  9 Fixed frequencies are available: 500 kHz, 1 MHz, 2 MHz, 3 MHz, 5 MHz, 10 MHz, 15 MHz, 35 MHz, and 50 MHz. 

Matched test clamp for DCS05 Test Generator, the Generator produces damped oscillatory wave transients in the frequency range 500kHz to 50 MHz that meet the definition of a type 1N Generator verification requirements Defence Standard 59-411.  9 Fixed frequencies are available: 500 kHz, 1 MHz, 2 MHz, 3 MHz, 5 MHz, 10 MHz, 15 MHz, 35 MHz, and 50 MHz. 

The Conformity Assessment Business Model DCS06 Clamp is designed and tuned for optimal operation in the 100 kHz frequency range and provides efficient coupling of the Defence Standard 59-411 DCS06 pulse to the EUT at voltages up to 1 kV (single turn output) and 4 kV (4 turn output). A single turn monitor loop is provided for pulse amplitude measurement during the test.

0.5 Ohm 1% Shunt Resistor, 200W

• used in MIL-STD, FORD, and other standards
• Low Inductance
• High Precision

1.0 Ohm 1% Shunt Resistor, 200W

• used in MIL-STD, FORD, and other standards
• Low Inductance
• High Precision

The Conformity Assessment Business Model CAB1001 Surge Inrush Compensator enables users to meet the 500A inrush requirement of EN 61000-4-11 irrespective of supply impedance.

The Surge Sense has been developed with EMC test laboratories in mind to enable a “go / no-go” verification of the surge generator output prior to test.