PLA-SET for Site Validation, Precision Loop Antenna 9 kHz - 30 MHz

The PLA set consists of two active, battery powered loop antennas intended for site validation. With the broad frequency range from 9 kHz to 30 MHz it is suitable for Normalized Site Attenuation (NSA) measurements and Shielding Effectiveness (SE) measurements.

Data Sheet

SPECIFICATIONS

PLA-SET for Site Validation

 

Precision Loop Antenna

 

The PLA set consists of two active, battery-powered loop antennas intended for site validation. With the broad frequency range from 9 kHz to 30 MHz, it is suitable for Normalized Site Attenuation (NSA) measurements and Shielding Effectiveness (SE) measurements.

Normalized Site Attenuation (NSA) measurement at 3 m, 5 m and 10 m distance is convenient due to sufficient dynamic range, all required documentation, and calibration. Setup and alignment is easy with the integrated tripod and laser system. A decoupling unit to avoid ground loops is included.

Shielding Effectiveness (SE) can be measured with a high dynamic. No external power amplifier or low noise preamplifier is required.

 

 

Product Highlights

  • Active transmit and receive antenna
  • Integrated tripod with laser alignment
  • Plenty of transmit power
  • Very low noise floor
  • Battery-powered
  • Individually calibrated
 

Applicable Standards

 

  • CISPR 16-1-4
  • EN 50147-1
  • IEEE 299

 

MS5 In CISPR 16-1-4 the NSA method to validate fully anechoic rooms in the frequency range 9 kHz – 30 MHz will be defined. Our PLA antennas including stand were specially designed to fulfill the requirements.
The PLA-Set is also suitable for SE measurements according to EN 50147-1 and IEEE 299
PLA-SET:
·     PLA-R (Receive Antenna System)
·     PLA-T (Transmit Antenna System)
·     Antenna stand for x, y and z orientation of the antenna
·     PLA-TC (Transmit Antenna Control Unit)
·     PLA-DC (Ground Loop Decoupling Unit)
·     Battery charger
·     flight case
software CalStan 11 MNSA Module 
OTHER PRODUCTS IN THE SAME CATEGORY:
Loading...